Skip to content
Waterproofing · Decks & balconies

Deck & balcony waterproofing

A deck over a bedroom is a roof you walk on. When it fails, water runs into framing you can’t see until the damage is expensive. We build walkable waterproofing systems that are detailed like roofs and finished like floors.

We install complete manufacturer systems — primer to top coat — including Gaco urethane deck systems as a Gaco Qualified Applicator, and fleece-reinforced Kemper System membranes where a deck needs to hold up under tile, pavers or heavy use.

Pedestrian deck coating over plywood

Pedestrian deck coating over plywood: 1. Plywood deck, sloped to drain, 2. Sheet-metal flashings, 3. Joint & detail reinforcement, 4. Primer, 5. Elastomeric base coat, 6. Wear coat + broadcast aggregate, 7. UV-stable top coat
Ideal for
  • Balconies and decks over living space
  • Rooftop decks and sundecks
  • Exterior walkways and stair landings
  • Apartment and condo balconies (SB 721 / SB 326 repairs)
  • Decks receiving tile or pavers
Why it works

Built to stay watertight, not just look finished.

Seamless and walkable

A fluid-applied membrane with no seams to open up, finished with a slip-resistant, UV-stable wearing surface in the color you choose.

Detailed where decks actually leak

Door thresholds, wall transitions, posts, drains and edges get sheet-metal flashings and reinforcement before a single coat goes down.

Built to the data sheet

Each coat is applied to the manufacturer’s specified thickness and checked with a wet-film gauge as we go — not eyeballed.

Tested before it’s finished

Where the assembly allows, decks are flood-tested before the wearing surface goes on, so a problem is found by us, not your ceiling.

Warranty-eligible

Because we install the full system as an approved applicator, eligible projects can be registered for manufacturer labor-and-material warranties.

Maintainable for decades

Urethane deck systems can be cleaned and re-top-coated as they wear, renewing the surface without tearing out the membrane.

The system

Pedestrian deck coating over plywood

A fluid-applied, multi-coat urethane system for walkable decks and balconies over living space — flashed first, reinforced at every joint, and finished with a slip-resistant, UV-stable wearing surface.

Layer by layer, from the substrate up

  1. 01Plywood deck, sloped to drainRe-fastened; slope corrected first
  2. 02Sheet-metal flashingsDoor pans, edge and wall metal set first
  3. 03Joint & detail reinforcementJoints, cracks and transitions
  4. 04PrimerMatched to the substrate
  5. 05Elastomeric base coatThe membrane, built to spec mils
  6. 06Wear coat + broadcast aggregateSlip resistance and abrasion protection
  7. 07UV-stable top coatColor finish that seals the aggregate
How we do it

Our process

  1. 01

    Open up and assess

    We check slope, sheathing, framing moisture and every transition. If framing is damaged, you see photos before anything is covered.

  2. 02

    Correct the substrate

    Repair or replace sheathing, correct slope to drain, and set door pans, edge metal and wall flashings.

  3. 03

    Build the membrane

    Reinforce joints and transitions, prime, and apply the base coat to the specified thickness — measured, recorded, photographed.

  4. 04

    Test, then finish

    Flood-test where the assembly allows, then apply the wear coat, aggregate and top coat for traction and UV protection.

Our standard

What we check on every job

  • Slope to drains or edges — 1/4" per foot wherever the structure allows — corrected before coating
  • Door pans and wall flashings installed under the membrane — never caulked on top
  • Moisture checks on sheathing and framing before we close anything in
  • Wet-film thickness recorded on every coat
  • Flood test (ASTM D5957) on decks over living space where the assembly allows
  • Full manufacturer system — no mixing components between brands
Read the full waterproofing standard
Warning signs

When to call us

  • Cracks or peeling in the existing coating
  • Soft spots or bounce underfoot
  • Stains or bubbling paint on the ceiling below
  • Water ponding for more than a day after rain
  • Rust at railing posts or edge metal
  • An SB 721 or SB 326 report calling for repairs
FAQ

Decks & balconies: questions & answers

Straight answers from the people who do the work.

How long does a deck coating last?

A properly installed urethane deck system typically gives many years of service, and its life can be extended by periodic cleaning and re-top-coating. Exposure, traffic and maintenance matter more than anything else; we give you a maintenance plan with every deck.

Can you coat over my existing deck coating?

Sometimes. If the existing membrane is well bonded and compatible, a recoat can be the right call. If it is delaminating, wet underneath or the slope is wrong, coating over it only hides the problem. We test adhesion and moisture before recommending either.

Do you handle SB 721 and SB 326 balcony repairs?

Yes. We repair and waterproof the exterior elevated elements identified in balcony inspection reports, and we coordinate with your inspector, architect or engineer so the repair scope matches their findings. Repairs under both laws must follow the manufacturer’s specifications and be permitted — which is exactly how we install. Many owners keep inspection and repair with separate firms to avoid any conflict of interest, and we’re glad to work that way.

Can I put tile or pavers over the waterproofing?

Yes, with the right membrane. Tile and paver assemblies need a membrane rated for use under a separate wearing surface. A fleece-reinforced liquid system such as Kemper System is often our choice there because it tolerates the loads and stays fully bonded.

Will the deck be slippery?

No. Aggregate broadcast into the wear coat gives the finished surface its traction. We can adjust the texture for barefoot comfort on roof decks or more grip on stairs and walkways.

Free assessment

Let’s keep the water out — for good.

Tell us what’s going on. We’ll inspect, explain what we find with photos, and give you a written, fixed-price proposal — usually within 48 hours of the visit.